Subject: Re: Mods for Standard 5718

In article gj6@vtc.tacom.army.mil, wx8l@vtc.tacom.army.mil (Sean McCarthy) 
writes:

1. Remove 4 screws and lift the top cover. (the top cover is the one
with the "TWIN BANDER" imprint.)

2. With the heatsink facing you, locate the vertical circuit board at the 
front of the C5718DA

3. Locate the row of three blue chip resistors at the lower right corner of 
the vertical circuit board, to the right of the connector labelled "CTD". 
Remove the blue chip resistor that is closest to the main circuit board.

4. Replace the cover, and preform the ALL RESET procedure described in the 
owners manual. The C5718DA is now configured for wide transmit.